Original Posted By: "Michael Brusilow"
Has anyone made the control horns from a single heavier 4130 (like maybe1/8) or would they bend too easily? Mark________________________________________________________________________________
Pietenpol-List: control horns
Re: Pietenpol-List: Aileron horns
Original Posted By: Larry Neal
----- Original Message -----
----- Original Message -----
Re: Pietenpol-List: control horns
Original Posted By: "DJ Vegh"
Subject: Re: Pietenpol-List: control hornsI believe the control horns Replicraft was making were solid steel.Heavier and probably not as stiff as the built up ones.I paniced when I looked at the Piet horns about a year ago too. Butonce you get the hang of it they're almost fun to make.Light and extremely strong. Ed G. ________________________________________________________________________________
Subject: Re: Pietenpol-List: control hornsI believe the control horns Replicraft was making were solid steel.Heavier and probably not as stiff as the built up ones.I paniced when I looked at the Piet horns about a year ago too. Butonce you get the hang of it they're almost fun to make.Light and extremely strong. Ed G. ________________________________________________________________________________
RE: Pietenpol-List: control horns
Original Posted By: owner-pietenpol-list-server(at)matronics.com
my GN1 has .090 4130 aileron/rubber/elevator horns. No welding or curvingrequired. Can make one in about 30 minutes.DJ VeghMesa, AZGN-1 Builderwww.raptoronline.comN74DV-----Original Message-----
my GN1 has .090 4130 aileron/rubber/elevator horns. No welding or curvingrequired. Can make one in about 30 minutes.DJ VeghMesa, AZGN-1 Builderwww.raptoronline.comN74DV-----Original Message-----