Pietenpol-List: go / no-go dimensions

[matronics]

Original Posted By: "Christian Bobka"
does anyone have a nicopress go/no-go guage they could measure with a set ofcalipers?I need to know what the acceptable thickness is for a 1/8" copper sleeveafter being compressed. I can't find my go/no-go guage anywhere and I wantto see if my nicopress tool is working properly.DJ VeghN74DVMesa, AZwww.imagedv.com/aircamper________________________________________________________________________________

[matronics]

Original Posted By: DJ Vegh
Are not the specs for the go no go in Ac 43?Chris Bobka----- Original Message -----

[matronics]

Original Posted By: "Christian Bobka"
i could not find them in the 43-13DJ VeghN74DVMesa, AZwww.imagedv.com/aircamper----- Original Message -----

[matronics]

Original Posted By: Jim Ash

[matronics]

Original Posted By: clif

[matronics]

Original Posted By: "Christian Bobka"
Yes p7-34Cy Galley - Bellanca Champion ClubNewsletter Editor & EAA TCwww.bellanca-championclub.comActively supporting Aeroncas every dayQuarterly newsletters on timeReasonable document reprints1-518-731-6800----- Original Message -----

[matronics]

Original Posted By: Cy Galley
Cy,Not in my book. It gives length after swaging but that is not very useful.chris----- Original Message -----

[matronics]

Original Posted By: "Christian Bobka"
Sorry I did not look closely enough.Cy Galley - Bellanca Champion ClubNewsletter Editor & EAA TCwww.bellanca-championclub.comActively supporting Aeroncas every dayQuarterly newsletters on timeReasonable document reprints1-518-731-6800----- Original Message -----