Pietenpol-List: Need pgs 44,45, 46, 47

[matronics]

Original Posted By: "Cy Galley"
Hey all. I am missing pages 44 through 47 of the ContinentalMaintenance and Overhaul Manual.I have a REALLY old manual and naturaly the only pages that cameun-stapled were the ones with the "Table of Limits".I have disassembled the engine ( I had to replace a damagedcam-follower.) I am ready to re-assemble it all bu I am curious as tothe wear on te crankshaft and camshaft. If somebody could scan anything that will tell me the diameters, I wouldgreatly appreciate it.Please respond off-line,Thanks, Bert Hey all. I am missing pages 44through 47 ofthe Continental Maintenance and Overhaul Manual.I have a REALLY old manual and naturalythe onlypages that came un-stapled were the ones with the "Table ofLimits".I have disassembled the engine ( I hadto replace adamaged cam-follower.) I am ready to re-assemble it all bu I am curiousas tothe wear on te crankshaft and camshaft. If somebody could scan anything thatwill tell methe diameters, I would greatly appreciate it.Please respond off-line,Thanks,Bert________________________________________________________________________________

[matronics]

Original Posted By: "Bert Conoly"
Besides the spec on page 46 you need to make sure that the "toe" of the camhas a 0.001 taper from side to side. This is necessary to make the camfollower rotate. If you don't, the follower face will get a groove.Cy Galley - Bellanca Champion ClubNewsletter Editor & EAA TCwww.bellanca-championclub.comActively supporting Aeroncas every dayQuarterly newsletters on timeReasonable document reprints----- Original Message -----

[matronics]

Original Posted By: "Cy Galley"
Thanks, CyI got the attachment - just what I neededBert----- Original Message -----