Original Posted By: "zieglera"
I thought I recently saw a thread on this but cannot find it.. So - sorry if this has been asked recently..Was wondering if I use stainless cable=2C do I use copper=2C aluminum or zinc crimps / thimbles=2C etc.. Seems odd that they wouldn't have stainless fittings to go along with it but I cannot find them anywhere. Same question if I were to use galvanized cable - although that seems more clear that I would use zinc fittings. Specifically=2C looking at doing the drag/anti-drag wires in the wings.Thanks=2CTom B. ________________________________________________________________________________Subject: Pietenpol-List: computer & internet
Pietenpol-List: computer & internet
Original Posted By: "C N Campbell"
Does sharing internet make the internet slow down on one computer? I have a pcand wireless laptop connected with a router. The internet on the laptop is fine.When the laptop is connected it makes my computer internet slow, the internetis slow not the computer. When the laptop is not connected the internet onthe computer works fine.--------my life my wayRead this topic online here:http://forums.matronics.com/viewtopic.p ... __________
Does sharing internet make the internet slow down on one computer? I have a pcand wireless laptop connected with a router. The internet on the laptop is fine.When the laptop is connected it makes my computer internet slow, the internetis slow not the computer. When the laptop is not connected the internet onthe computer works fine.--------my life my wayRead this topic online here:http://forums.matronics.com/viewtopic.p ... __________
Re: Pietenpol-List: cable and fittings
Original Posted By: TOM MICHELLE BRANT
Tom, somewhere someone said not to use stainless cable but I can't remember the reason. I am using galvanized 3/32 cable with zinc plated copper crimps. If one is put on improperly it is a bear to get off. You have to cut the fitting in about four places to pry the crimp off. This is in places where you don't want to cut the cable. Chuck C.Do not save. ----- Original Message -----
Tom, somewhere someone said not to use stainless cable but I can't remember the reason. I am using galvanized 3/32 cable with zinc plated copper crimps. If one is put on improperly it is a bear to get off. You have to cut the fitting in about four places to pry the crimp off. This is in places where you don't want to cut the cable. Chuck C.Do not save. ----- Original Message -----
Pietenpol-List: cable and fittings
Original Posted By: Michael Perez