Brodhead Pietenpol Association

Original Posted By: "walter evans"
Here is a quick, reasonably dumb question, but I'll ask it anyway:I'm ordering tubing, flat steel, etc. to make metal parts, and I came to the bushing material for the controls, and I see 1/4", 3/8" I assume that these are OD and not ID measurments?thanks,Gary Meadows________________________________________________________________________________

Original Posted By: Gary Meadows
If it's tubing like from an aircraft catalog, yes this is OD. So betweenthat and the wall thickness that is listed , you can figure out ID. Somecatalogs list ID.walt---------------------------------------------------------- Original Message -----