Page 1 of 1
Pietenpol-List: Cowlings
Posted: Mon Dec 03, 2001 3:02 pm
by matronics
Original Posted By: Isablcorky(at)aol.com
Subject: Pietenpol-List: CowlingsPieters,Bought a sheet of Alclad 2024-T3 .020. Is this thick enough for Piet cowlings? The price was right.Corky in La working hard.________________________________________________________________________________
Pietenpol-List: Cowlings
Posted: Mon Dec 03, 2001 3:02 pm
by matronics
Original Posted By: Isablcorky(at)aol.com
Subject: Pietenpol-List: CowlingsPieters,Bought a sheet of Alclad 2024-T3 .020. Is this thick enough for Piet cowlings? The price was right.Corky in La working hard.________________________________________________________________________________
Re: Pietenpol-List: photo share- Mr. Sam
Posted: Mon Dec 03, 2001 7:01 pm
by matronics
Original Posted By: "Dick and Marge Gillespie"
Subject: Re: Pietenpol-List: photo share- Mr. SamWhat was/is the difference in cruise speed of your Piet of the two engines?Corky in La________________________________________________________________________________
Re: Pietenpol-List: Cowlings
Posted: Mon Dec 03, 2001 7:16 pm
by matronics
Original Posted By:
Corky,I used 2024T3 at .025 and it worked fine.DickG.----- Original Message -----
Re: Pietenpol-List: Cowlings
Posted: Mon Dec 03, 2001 7:30 pm
by matronics
Original Posted By: "Michael Brusilow"
Subject: Re: Pietenpol-List: CowlingsGood,Mr Harvey sold me this sheet today for $25. Enough for all my cowlings. It says in print .020 but it miced out about .027. Plenty strong. Doug, how far along are you? Will you be able to fly to Abbeville with Ted next year for the 1st annual Pietenpol Louisiana Shrimp eating fly-in? Oysters too.Corky in La pulling those heads as fast as I can.________________________________________________________________________________
Re: Pietenpol-List: photo share- Mr. Sam
Posted: Mon Dec 03, 2001 7:53 pm
by matronics
Original Posted By: Isablcorky(at)aol.com
----- Original Message -----
Re: Pietenpol-List: photo share- Mr. Sam
Posted: Mon Dec 03, 2001 8:02 pm
by matronics
Original Posted By: Isablcorky(at)aol.com
----- Original Message -----