Page 1 of 1
RE: Pietenpol-List: Laser cut GN-1 parts available - please respond if
Posted: Thu Apr 24, 2003 1:06 am
by matronics
Original Posted By: owner-pietenpol-list-server(at)matronics.com
DJ, did you ask them if they would do 4130. I noticed that somewhere in theprogram you could make a special request with your order for differentmaterials. It would sure be worth a note to them.-Gary-----Original Message-----
Re: Pietenpol-List: Laser cut GN-1 parts available - please respond if
Posted: Thu Apr 24, 2003 9:16 am
by matronics
Original Posted By: "Gary McNeel"
I want Titanium ~!!!!----- Original Message -----
Re: Pietenpol-List: Laser cut GN-1 parts available - please respond if
Posted: Thu Apr 24, 2003 9:41 am
by matronics
Original Posted By: "Gary McNeel"
Gary I am sure they can get 4130. I'll bet the cost goes up about 15%though. Thier readily available materials are cheap because they have themin quantity.4140 is good for parts not requiring welding though.But, I'll see what they say about 4130.DJ VeghN74DVwww.raptoronline.comMesa, AZ----- Original Message -----
Re: Pietenpol-List: Laser cut GN-1 parts available - please respond if
Posted: Thu Apr 24, 2003 9:45 am
by matronics
Original Posted By: "Ken Rickards"
Ken,I'll certainly save the drawings. I'll also save the extra parts I will begetting, but I'd really like to get rid of them ASAP. Tell ya what... I'lllet you have the steering horns, elevator horns & walking beam supports for$40. It'll be impossible to beat that price if you have them cut on yourown on a small run order.lemme know,DJ VeghN74DVwww.raptoronline.comMesa, AZ----- Original Message -----