Brodhead Pietenpol Association

Original Posted By: "Jim Markle"
Jim,That is good stuff. It is what I used on the Waco Taperwing ribs. I eventhink it is better than the U. S. made MIL-W-6070 plywood. The BS1088 ismahoghany throughout while the 6070 is poplar core.I had purchased mine at Aircraft Spruce about 9 years ago. They no longercarry it.Where did you guys get it again? Do you have an address in phone number? Imight have to do a long Dallas layover and buy some and ship it back to MN.Chris Bobka----- Original Message -----

Original Posted By: "Christian Bobka"
Plywood & Doorhttp://www.pdusa.com/contact.htmThey're located in Chicago, Dallas, LA and New York.For comparison, I bought a 4X8 sheet of plywood (around 5/16" or 3/8" thick)for about $50. Wicks/AS&S was well over $200 (plus shipping) for the samesize.But I wasn't able to just walk in and buy. I had to go through a lumberyard (the one where I buy my Douglas Fir). You can probably talk them intoselling directly to you. When Tom bought directly from them, he apparentlyapplied a higher level of schmoozing (some may need to look that up in"Yiddish for Dummies") than I....... :-)jm----- Original Message -----

Original Posted By: Dave and Connie

Original Posted By: Kip & Beth Gardner