Brodhead Pietenpol Association

Original Posted By: BARNSTMR(at)aol.com
If anybody is interested, we started covering last weekend....I posted a few new pictures to my websiteBerthttp://bconoly.tripod.com/________________________________________________________________________________

Original Posted By: "Bill Church"

Original Posted By: "Skip Gadd"
Just updated my site with some new fuselage pictures. Hope it helps thoseat that stage.JackDSMwww.textors.com ________________________________________________________________________________

Original Posted By: "Richard Schreiber"
Rick,I used Buchanan's 9-10 ga SS spokes, they are about .140 tho. I drilled 3/16 holeswhich is about .185 tho. With the chamfer on both edges of the hole it waseasy to lace the wheels.SkipFellow Pieters:for those that have made the straight axle gear using the Henderson/Pavliga/Perkinsstyle hubs, what size holes did you drill in the hubs for your spokes. Irealize it is spoke size dependent, but my plans are to go with 9 ga. spokes fromBuchanan's. I want to make sure that the hubs that I send to them are drilledcorrectly.Rick SchreiberValparaiso, IN________________________________________________________________________________

Original Posted By: Jack Phillips
Jack and Skip,Thanks for the response. I tried calling Bucanan's Saturday, but only got a voicemail.I will either try e-mail or call them again tomorrow.Rick Schreiber----- Original Message -----