Pietenpol-List: lining up tail section hinges
Posted: Wed Aug 11, 2004 12:22 am
Original Posted By: Gary W Meadows
Subject: Pietenpol-List: lining up tail section hingesI've made a router jig for routing the tail section hinges flush to the outsideof the beams.. I've read some mention previously of lining up the hinges (usingVi Kapler hinges). Is this difficult to do? In my jig I've allowed for about3/32" of play all the way around so that slight adjustments can be made.I read where people were having trouble lining up the holes for the hinges. When I hold two pieces together, the holes seem to match up fine.Maybe I'm missing something. Any comments?Tom B.________________________________________________________________________________Date: Wed, 11 Aug 2004 11:05:18 -0700 (PDT)
Subject: Pietenpol-List: lining up tail section hingesI've made a router jig for routing the tail section hinges flush to the outsideof the beams.. I've read some mention previously of lining up the hinges (usingVi Kapler hinges). Is this difficult to do? In my jig I've allowed for about3/32" of play all the way around so that slight adjustments can be made.I read where people were having trouble lining up the holes for the hinges. When I hold two pieces together, the holes seem to match up fine.Maybe I'm missing something. Any comments?Tom B.________________________________________________________________________________Date: Wed, 11 Aug 2004 11:05:18 -0700 (PDT)