Pietenpol-List: Re: Information on fitting props to Model A Ford Engines
Posted: Mon Oct 24, 2005 4:46 am
Original Posted By: "Oscar Zuniga"
Some time ago I requested information on your website relating to fitting propsto Model A Ford engines. I particularly wanted information on any torque valuefor the main nut, bolting the prop flange to crankshaft.The other question was - "is there any information on the correct additive to thecoolant which will give both corrosive protection and lubrication for the waterpump. So far I have not received any replies.I am helping assemble a Pietenpol in Western Australia which is a very isolatedplace. We have no local knowledge of Piets out here.Any suggestions would be greatly appreciated.Kind regards.Graham Hewitt________________________________________________________________________________
Some time ago I requested information on your website relating to fitting propsto Model A Ford engines. I particularly wanted information on any torque valuefor the main nut, bolting the prop flange to crankshaft.The other question was - "is there any information on the correct additive to thecoolant which will give both corrosive protection and lubrication for the waterpump. So far I have not received any replies.I am helping assemble a Pietenpol in Western Australia which is a very isolatedplace. We have no local knowledge of Piets out here.Any suggestions would be greatly appreciated.Kind regards.Graham Hewitt________________________________________________________________________________