Page 1 of 1
Pietenpol-List: Wing leading-edge tool
Posted: Sun Oct 30, 2005 2:44 pm
by matronics
Original Posted By: Alexms1(at)comcast.net
Hello! I'm posting to ask if anyone's built/used a tool to sand/shave a wing leading-edge from the rough. Our Dave's been rasping it from outlines drawn on the ends, using a template made from gusset material to confirm his work. We've got several devoted people putting a lot of creativity into our Piet, and I thought this'd be an opportunity to contribute to the project, and also contribute a little to this list, which has been good to belong to. Thanks! Sincerely, Dave Smith
http://www.eaa1279.org/Pietenpol.htm___ ... __________
Re: Pietenpol-List: Wing leading-edge tool
Posted: Sun Oct 30, 2005 9:57 pm
by matronics
Original Posted By: Lou Wither
David,Did you see the way Michael Cuy did his? He bought stairwell banisters and madetwo passes on his table saw and they were ready to glue on. His tape showshow he did this.Alex Sloan-------------- Original message -------------- Hello! I'm posting to ask if anyone's built/used a tool to sand/shave a wing leading-edge from the rough. Our Dave's been rasping it from outlines drawn on the ends, using a template made from gusset material to confirm his work. We've got several devoted people putting a lot of creativity into our Piet, and I thought this'd be an opportunity to contribute to the project, and also contribute a little to this list, which has been good to belong to. Thanks! Sincerely, Dave Smith
http://www.eaa1279.org/Pietenpol.htmDavid,Did you see the way Michael Cuy did his? He bought stairwell banisters and madetwo passes on his table saw and they were ready to glue on. His tape shows howhe did this.Alex Sloan-------------- Original message -------------- Hello!I'm posting to ask if anyone's built/used a tool to sand/shave a wing leading-edge from the rough. Our Dave's been rasping it from outlines drawn on the ends, using a template made from gusset material to confirm his work.We've got several devoted people putting a lot of creativity into our Piet, and I thought this'd be an opportunity to contribute to the project, and also contribute a little to this list, which has been good to belong to. Thanks!Sincerely,Dave Smithhttp://
www.eaa1279.org/Pietenpol.htm__________ ... ______Date: Mon, 31 Oct 2005 04:11:12 -0800 (PST)
RE: Pietenpol-List: Wing leading-edge tool
Posted: Mon Oct 31, 2005 6:20 am
by matronics
Original Posted By: "Phillips, Jack"