Brodhead Pietenpol Association

Original Posted By: "Catdesign"
Subject: Pietenpol-List: Spring ShocksPieters, I'm holding a page from the "Pietenpol Construction New" undated. Top half of page has two letters and a captioned picture of a Piet underway. The lower half deals with the "Landing Gear Strut-Coil Spring Shock absorbing" There is a fine technical drawing of the device. It lists the coil spring as an "H-56 -Lamina-3/4IDX 1 1/2 ODX6 inches". Even though I have completed my gear and shocks I'm fearful that the coils are too strong and should be changed. Would anyone know the source of these H-56 Lamina springs. Would sure appreciate some help on this one. Corky in Cool Louisiana________________________________________________________________________________

Original Posted By: Isablcorky(at)aol.com
See their webpage for a catalog ( http://www.anchorlamina.com )Die and Mold components are available from any of the Die Set manufacturing plantslisted below as well as from over 500 distributors world wide.For a distributor near you, please contact: Lamina Components 38505 Country Club Drive, Suite 100 Farmington Hills, MI 48331 USA Toll Free 1-800-6-LAMINA Tel. (248) 489-9122 Fax. (248) 553-6842 or (800) 406-4410Chris TracySacramento, Ca ----- Original Message -----