Page 1 of 1

Pietenpol-List: For Sale - Piet Ribs

Posted: Mon Jan 15, 2007 1:34 am
by matronics
Original Posted By: "Jack T. Textor"
Hey Don, Glad to hear your finally going to build a Piet. I soaked my wing upper wing rib piece in my bathtub for about 2 or 3 hours so I could bend it. They are nice and wet when I take them out, as in really wet and pliable. I have not noticed any staining, weakness or discoloration from this. What you need to watch out for is getting a piece of dusty or dirty wood wet. This will drive the dirt into the wood and stain it. Also, some how something leaked into my fuselage and stained the mahogany plywood on the floor. I think it was water off the garage door as I would open it though I'm not sure as I never saw it drip nor have I since seen it drip. In any event I think the plywood might stain easily. I would think if you wrap it up as tight as you can you will be fine. Just make sure you open it up to dry out as soon as possible.Chris TracySacramento, CaWebsite at http://www.Westcoastpiet.com________________________________________________________________________________Subject: Pietenpol-List: For Sale - Piet RibsDate: Mon, 15 Jan 2007 08:54:40 -0600

Re: Pietenpol-List: For Sale - Piet Ribs

Posted: Mon Jan 15, 2007 10:07 am
by matronics
Original Posted By: amsafetyc(at)aol.com

Pietenpol-List: For Sale - Piet Ribs

Posted: Mon Jan 15, 2007 10:54 am
by matronics
Original Posted By: shad bell