Brodhead Pietenpol Association

Original Posted By: "Douwe Blumberg"
I hate to part with it=2C but I need the money...I have nearly everything needed for a William Wynne type conversion with probably $1700-$1800 invested. At that price you'd get all I have for some savings based on the current costs (I bought it a couple years ago) but I'll accept any reasonable offer - I want to see this stuff get used. The only major components I don't have is the rods (I have cores) and rebuilt heads (I have many cores). I could deliver to Oshkosh for sure=2C or Brodhead possibly=2C or you could pick-up at my home near Minneapolis=2C MN.Contact me off list if you're sincerely interested - I don't want everyone just hunting for a lowball deal - I'm not giving it away - remember=2C I said "reasonable offer" =3B ) I can provide a complete list of what I have off list.Thanks=2CTom B.________________________________________________________________________________

Original Posted By: "Will42"
A while back someone was asking about the aluminum buick/olds V8 being usedin piets and I wrote that I'd look through my old backissues.Found this one with a picture from 94'Steve Cavanaugh54 Old Verowra rdNornsby NSW 2077It's his third piet and is using the rover V8 which is our buick/oldsQuotes "good performance, no problems"I can tell from the photo it is direct drive.Douwe________________________________________________________________________________Subject: Pietenpol-List: Re: aluminum buick/olds/rover in piets

Original Posted By:
Douwe; do you have a picture you could post? Thanks........WillRead this topic online here:http://forums.matronics.com/viewtopic.p ... __________