Brodhead Pietenpol Association

Posted: **Sun Oct 04, 2009 8:57 pm**

Original Posted By: owner-pietenpol-list-server(at)matronics.com [mailto:owner-pietenpol-lis
Michael,=C2-I don=99t have that info at my fingertips, but consider that you may want to thread the ends for the Aurora bearings. Pick an appropriate ID and wall thickness based on the bearings you choose.=C2-Gary BootheCool, Ca.PietenpolWW Corvair Conversion, mountedTail done,=C2-Fuselage=C2-on gear(15 ribs down)

Posted: **Mon Oct 05, 2009 12:19 pm**

Original Posted By: Michael.D.Cuy(at)nasa.gov

Posted: **Mon Oct 05, 2009 12:57 pm**

Original Posted By: owner-pietenpol-list-server(at)matronics.com
Michael,I don't have that info at my fingertips, but consider that you may want tothread the ends for the Aurora bearings. Pick an appropriate ID and wallthickness based on the bearings you choose.Gary BootheCool, Ca.PietenpolWW Corvair Conversion, mountedTail done, Fuselage on gear(15 ribs down.) _____

Brodhead Pietenpol Association

Pietenpol-List: Push/pull linkage size/type

RE: Pietenpol-List: Push/pull linkage size/type

Pietenpol-List: Push/pull linkage size/type

RE: Pietenpol-List: Push/pull linkage size/type