Pietenpol-List: engine cooling -resending -ignore earlier email

matronics · Post by **matronics** » Thu Jan 21, 2010 6:03 pm

Original Posted By: airlion

matronics · Post by **matronics** » Thu Jan 21, 2010 7:55 pm

Original Posted By: owner-pietenpol-list-server(at)matronics.com
Gardiner,Might be a good question to post on the Corvair list, too, but are you sureyou have enough 'vent' at the bottom to exhaust the air? And equally sureyou have a good seal around your fairings? And...this is a longshot...but,on my Aeronca Sedan, I had a CHT gauge that was just plain wrong. I finallydiscovered it when I put the end in some boiling water...did you know thatwater actually boils at 300deg? ;-0Gary BootheCool, CAPietenpolWW Corvair ConversionTail done, Fuselage on gear16 ribs done-----Original Message-----

matronics · Post by **matronics** » Thu Jan 21, 2010 8:55 pm

Original Posted By: shad bell

matronics · Post by **matronics** » Thu Jan 21, 2010 9:08 pm

Original Posted By: "pietlover5145"
I am sure you have checked both the sender and the gauge. What is your oil temperaturedoing ? And did you clean out all the aluminum flashing from the headsduring the rebuild. Temperature seems very high if you are certain that airis moving through the engine compartment. Double check ignition timing. Whatcarb are you using ?DWRead this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: Selling my Pietenpol Project

matronics · Post by **matronics** » Thu Jan 21, 2010 9:13 pm

Original Posted By: amsafetyc(at)aol.com
Hello to the wonderful and very generous piet group. Ryan and I have been tallyingyour pledges and man, it is overwhelming. We have had more than 46 peoplecommit to donations for Markle Mania and our grand total so far is $3,760. Ourhighest donation so far has been $150, and we have had contributors from as faraway as Australia and South America. List-regulars, lurkers, family and friendshave all offer their contributions and they are all greatly appreciated.Here are some websites that you can visit to get into the Markle Mania spirit:John Hofman's Salute to Jim Markle http://gallery.me.com/johnnyskyrocket#100017 Ryan's Updated Donation Tally: http://users.rcn.com/ryan.mueller/markle.htmThis new and updated site also includes confidential tallys of donations.And of course, you may email marklepietenpolfund(at)gmail.com to make a pledge.I hope that we can make this dream happen for Jim and his family. Thank you allso much for your tireless efforts and heartfelt donations!Read this topic online here:http://forums.matronics.com/viewtopic.p ... __________

matronics · Post by **matronics** » Thu Jan 21, 2010 9:31 pm

Original Posted By: Ryan Mueller
Subject: Re: Pietenpol-List: Re: Selling my Pietenpol ProjectJess,Thanks for the update. Hard to believe just 24 hours ago we had an idea and now we are almost 2/3 there. I don't know where or how where we could ever find a finer bunch of folks. I hope the spirit keeps the Markle O Mometer rising to the goal. We are rapidly approaching the mark it would be great to get to it by the closing of the market.Markle a man of his word, has told me if we don't hit it by closing time then its over, he's not willing or wanting to drag this on or out. Once its done its done no going back and no regrets I agreed with him. So the time table has been set we are 23 hours down and 2/3 there well almost.In a message dated 1/21/2010 10:15:21 P.M. Eastern Standard Time, jessica.ozbirn(at)gmail.com writes:http://users.rcn.com/ryan.mueller/markl ... ______Date: Thu, 21 Jan 2010 22:33:39 -0600Subject: Re: Pietenpol-List: Re: Selling my Pietenpol Project

matronics · Post by **matronics** » Fri Jan 22, 2010 8:01 am

Original Posted By: hvandervoo(at)aol.com

matronics · Post by **matronics** » Fri Jan 22, 2010 8:07 am

Original Posted By: Douwe Blumberg

matronics · Post by **matronics** » Fri Jan 22, 2010 8:31 am

Original Posted By: amsafetyc(at)aol.com
I'm in for 60 bucks.Read this topic online here:http://forums.matronics.com/viewtopic.p ... __________

matronics · Post by **matronics** » Fri Jan 22, 2010 5:12 pm

Original Posted By: "kevinpurtee"
Jim did the same for me when I started my project last spring. An ambassador indeed, and definitely a good guy. Bill Church wrote:> almost six years ago, I decided to take the plunge. I ordered my plans, andI made my first "real" post to the List, asking some typical newbie questions.One of the first replies came offlist, from some guy named Jim Markle, who wasliving in Plano, TX at the time. He forwarded me a copy of his "Pietenpol Builder'sGuide to the Universe" (which he has since posted at Mykitplane.com),and offered to send me some Pietenpol photos on a CD. --------Mark - working on wingsRead this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: engine cooling -resending -ignore earlier email

matronics · Post by **matronics** » Fri Apr 28, 2017 9:34 pm

Original Posted By: "Gary Boothe"
> --> Pietenpol-List message posted> by: "K5YAC" > > Nope, I got the straight skinny from the horse's> mouth, or in this case, the Markle himself. This was> just another chain jerking by our resident prankster and> rumor starter, John Recine. Had me going for a while> too.> > --------> Mark - working on wings> > > > > > Read this topic online here:> > http://forums.matronics.com/viewtopic.p ... 728#282728> > > > > > > > Email Forum -> FAQ,> - MATRONICS WEB FORUMS -> List Contribution Web Site -> -Matt> Dralle, List Admin.> > > >________________________________________________________________________________

Brodhead Pietenpol Association