Brodhead Pietenpol Association

Original Posted By: "skellytown flyer"
Thanks for the tips everybody!i do actually have all the capstrip cut already-(and the sander got ALOT of use!)and i do have a similar bin setup to yours Mark, but, while cutting the gussetsi just got a little ahead of myself and finished one set of gussets for arib-i should have all of the remaining gussets cut by the weekend! --------Earl BrownI may not have gone where I intended to go, but I think I have ended up where Iintended to be.Read this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: Electrical

Original Posted By: Rick Holland
at7000ft wrote:> I have heard that Georgia rednecks are the worst kind (as far as rednecks go).Then they must be tied with Arkansas rednecks. [Laughing]--------Mark ChouinardFinishing up Wings - Working on Center SectionRead this topic online here:http://forums.matronics.com/viewtopic.p ... ______Date: Thu, 1 Jul 2010 21:39:24 -0600Subject: Re: Re: Re: Pietenpol-List: Electrical

Original Posted By: Rick Holland
bencharvet(at)gmail.com wrote:> Its more fun to do it the way I did, with 3/8 inch aircraft nails held > with needle nose pliers tapped in with a tack hammer. I remember it as > a character building experience :-)Same here... definitely a lesson in patience. I drove over 3700 nails using atac hammer and needle nosed-pliers. 126 nails per rib... more in the 6 end ribswith extra gussets. I didn't pull mine... left em in place.--------Mark ChouinardFinishing up Wings - Working on Center SectionRead this topic online here:http://forums.matronics.com/viewtopic.p ... ______Date: Thu, 1 Jul 2010 21:40:42 -0600Subject: Re: Re: Re: Pietenpol-List: Electrical

Original Posted By: Jim