Page 1 of 1
Pietenpol-List: metal size for tail fittings
Posted: Mon Sep 20, 2010 5:19 am
by matronics
Original Posted By: jorge lizarraga
i've been going through the archives and just want to double check-Is .080 good for the tail fittings or should i use .090?Also, is .032 good for the tail control horns?I have all the wood for the tail on the way and am ready to call Dillsurgto order the metal for the fittings.Thanks for any help-Earl--------Earl BrownI may not have gone where I intended to go, but I think I have ended up where I intended to be.Read this topic online here:
http://forums.matronics.com/viewtopic.p ... 7#313067le, List Admin.=0A=0A=0A ________________________________________________________________________________Date: Tue, 21 Sep 2010 21:48:49 -0700 (PDT)
Pietenpol-List: metal size for tail fittings
Posted: Mon Sep 20, 2010 10:05 am
by matronics
Original Posted By: "echobravo4"
I would like to have them.Chethartley1(at)mchsi.com573-645-0534Sent from my iPhoneOn Sep 20, 2010, at 8:26 AM, Oscar Zuniga wrote:> > > I have a new and unused set of plans for the> "Pedal Piet" for young children:> >
http://www.pedalplanekits.com/piet.html> > These plans cost about $25 from Aviation Products.> If you're interested in these plans, email me> off-list. If you start building today, you could> have a Christmas present for your favorite young> Piet pilot. $15 to the first responder. Thanks!> > Oscar Zuniga> Air Camper NX41CC> San Antonio, TX> mailto: taildrags(at)hotmail.com> website at
http://www.flysquirrel.net > > > > ________________________________________________________________________________Subject: Pietenpol-List: metal size for tail fittings
Posted: Mon Sep 20, 2010 12:19 pm
by matronics
Original Posted By: Tim Willis
i've been going through the archives and just want to double check-Is .080 good for the tail fittings or should i use .090?Also, is .032 good for the tail control horns?I have all the wood for the tail on the way and am ready to call Dillsurgto order the metal for the fittings.Thanks for any help-Earl--------Earl BrownI may not have gone where I intended to go, but I think I have ended up where Iintended to be.Read this topic online here:
http://forums.matronics.com/viewtopic.p ... ______Date: Mon, 20 Sep 2010 13:38:50 -0500 (GMT-05:00)
> Pietenpol-List: metal size for tail fittings
Posted: Mon Sep 20, 2010 1:58 pm
by matronics
Original Posted By: Jim Boyer
> Pietenpol-List: metal size for tail fittings
Posted: Mon Sep 20, 2010 2:15 pm
by matronics
Original Posted By: Michael Groah
Pietenpol-List: Re: Sticker
Posted: Mon Sep 20, 2010 3:52 pm
by matronics
Original Posted By: Jim Boyer
I'll purchase one as well. Just post the details and I'll send you some money.--------JohnRead this topic online here:
http://forums.matronics.com/viewtopic.p ... ______Date: Mon, 20 Sep 2010 22:14:27 +0000 (UTC)