Page 1 of 1
Pietenpol-List: jury strut attach idea I saw on Will Graff's Pietenpol
Posted: Wed Dec 08, 2010 9:16 am
by matronics
Original Posted By: "Richard Schreiber"
Subject: Pietenpol-List: jury strut attach idea I saw on Will Graff's PietenpolAnd copied it. Sketch attached. Works well, was easy to fabricate.Mike C.[cid:image001.jpg(at)01CB96C0.F22CA350]rsbooks.com>m>________________________________________________________________________________
RE: Pietenpol-List: jury strut attach idea I saw on Will Graff's Pietenpol
Posted: Wed Dec 08, 2010 10:55 am
by matronics
Original Posted By: Cuy, Michael D. (GRC-RXD0)[ASRC AEROSPACE CORP]
Mike,Thats the design I plan on using. I plan on working on the cowling from the firewall rearward this month. I onlywant to pay shipping once, so I hope that a full 4x12 ft sheet will be enoughto do the cockpits and the engine cowl. I'm using .025 2024T3.I saw Jim Hacklin and his Piet a couple of days ago. I am sure he will be flyingthis spring. He has just about finished his Corvair. I think all he has leftto do is install the carb and then cowl the engine. The day I saw him we weredue to get about 10 inches of lake effect snow. Our conversation naturally gravitatedto open cockpit flying in the winter and how much we would actually doit. If I had skis like Don, I might be more inclined to do it. Rick Schreiber----- Original Message -----
Pietenpol-List: Re: jury strut attach idea I saw on Will Graff's Pietenpol
Posted: Wed Dec 08, 2010 12:00 pm
by matronics
Original Posted By: "Bill Church"
Hey John Check this out.Dick N.________________________________________________________________________________Subject: Pietenpol-List: Re: jury strut attach idea I saw on Will Graff's Pietenpol