RE: RE: Pietenpol-List: Re: Additional questions regarding split axle
Posted: Thu Jan 06, 2011 5:49 am
Original Posted By: owner-pietenpol-list-server(at)matronics.com
Old "slow poke" Jack made another mistake last night. As mentioned I'mplanning to do the bottom plates and strap under the floor in one piece.Well, measured twice and cut once, ok that was fine. Marked it for the 20degree bend, checked it twice then off to the brake. Perfect 20 degrees',trial fit with side plates looked good. Oh crap! Let's not forget theplywood sides that need to be added. Will clamp small scrap in all gearareas to remember next time. That my tip of the week.JackDSM _____
Old "slow poke" Jack made another mistake last night. As mentioned I'mplanning to do the bottom plates and strap under the floor in one piece.Well, measured twice and cut once, ok that was fine. Marked it for the 20degree bend, checked it twice then off to the brake. Perfect 20 degrees',trial fit with side plates looked good. Oh crap! Let's not forget theplywood sides that need to be added. Will clamp small scrap in all gearareas to remember next time. That my tip of the week.JackDSM _____