Page 1 of 1
Pietenpol-List: 3/8" 4130 Rod
Posted: Tue Feb 15, 2011 8:05 am
by matronics
Original Posted By: Jim Markle
Pietenpol-List: 3/8" 4130 Rod
Posted: Tue Feb 15, 2011 9:01 am
by matronics
Original Posted By: shad bell
Re: Pietenpol-List: 3/8" 4130 Rod
Posted: Tue Feb 15, 2011 11:49 am
by matronics
Original Posted By: Michael Perez
Do you mean rod or tubing? The .065 wall would indicate tubing. I'm getting ready to order some hardware from AS & S and could order you a foot. Chuck ----- Original Message -----
Pietenpol-List: Re: 3/8" 4130 Rod
Posted: Tue Feb 15, 2011 1:29 pm
by matronics
Original Posted By: "Jerry Dotson"
Those wicker seats are great... where did you find those?--------Brad "DOMIT" SmithFirst rule of ground school: This is the ground... don't hit it going fast.Read this topic online here:
http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: 3/8" 4130 Rod
Posted: Tue Feb 15, 2011 1:40 pm
by matronics
Original Posted By: "Jack"
I have the 3/8 4130 rod but not the tube. I would gladly send you some.--------Jerry Dotson59 Daniel Johnson RdBaker, FL 32531Started building NX510JD July, 2009wing, tailfeathers done, fuselage rollingusing Lycoming O-235Read this topic online here:
http://forums.matronics.com/viewtopic.p ... __________
Re: Pietenpol-List: 3/8" 4130 Rod
Posted: Tue Feb 15, 2011 6:29 pm
by matronics
Original Posted By: Michael Perez
Re: Pietenpol-List: 3/8" 4130 Rod
Posted: Tue Feb 15, 2011 6:32 pm
by matronics
Original Posted By: Michael Perez
Re: Pietenpol-List: found some.....: 3/8" 4130 Rod
Posted: Thu Feb 17, 2011 7:38 am
by matronics
Original Posted By: Jim Markle
Pietenpol-List: Re: 3/8" 4130 Rod
Posted: Thu Feb 17, 2011 10:55 am
by matronics
Original Posted By: "K5YAC"
Steve; please email me off list if you still have the prop. Thanks.--------Oscar ZunigaSan Antonio, TXAir Camper NX41CCRead this topic online here:
http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: 3/8" 4130 Rod
Posted: Thu Feb 17, 2011 1:04 pm
by matronics
Original Posted By: Jim Markle
dfwplt wrote:> Pryor, OK...where it was -20F last Wednesday....today's forecast: 70F...> Are you out there making use of this nice weather?--------Mark ChouinardWings, Center Section and Empannage framed up - Working on FuselageRead this topic online here:
http://forums.matronics.com/viewtopic.p ... ______Date: Thu, 17 Feb 2011 14:06:05 -0600 (GMT-06:00)