Brodhead Pietenpol Association

Original Posted By: "Gary Boothe"
Hi Everybody-Ok- this would have been easier if i would have a noticed it beforethe doubler's were glued in but....Any way since I can't get to the outer most hinge screws on the horizontalstab. because of the diagonal brace i am wondering if this would work.I have recessed an anchor nut into 16th ply and was going to epoxythe ply to the back side of the hinge doubler (already glued in !)I thought that might be better than trying to get a regular blind nutin there or just gluing in a nut.thanks for the help-AGAIN!Earl--------Earl BrownI may not have gone where I intended to go, but I think I have ended up where Iintended to be.Read this topic online here:http://forums.matronics.com/viewtopic.p ... ttachments: http://forums.matronics.com//files/anch ... __________

Original Posted By: echobravo4
Earl,I drilled an 1" access hole in mine on one side...same problem.Gary Boothe-----Original Message-----

Original Posted By: Ken Bickers
Subject: Re: Pietenpol-List: Ooop's

Original Posted By: Earnest Bunbury
I know this is off topic, but I know a lot of you have seen their act and knowwho they are. Kyle and Amanda were seriously injured in a crash at the Brownsvilleairshow today.Please keep them both in your prayers.Thanks. LarryRead this topic online here:http://forums.matronics.com/viewtopic.p ... ______Date: Sat, 12 Mar 2011 19:54:52 -0500Subject: Re: Pietenpol-List: Good read about Jeff Boatright

Original Posted By: Ben Charvet