Page 1 of 1
Pietenpol-List: Trailing edge treatment
Posted: Wed May 25, 2011 12:29 pm
by matronics
Original Posted By: Jack
Jack T.,This is exactly the way I did it, only I used 3/32 ply I think. Worked very well.Dan HelsperPuryear, TN-----Original Message-----
Pietenpol-List: Re: Trailing edge treatment
Posted: Wed May 25, 2011 1:08 pm
by matronics
Original Posted By: "Ray Krause"
What? That's not the way Ber-nerd did it!--------Mark ChouinardWings, Center Section and Empannage framed up - Working on FuselageRead this topic online here:
http://forums.matronics.com/viewtopic.p ... ttachments:
http://forums.matronics.com//files/te_t ... __________
Re: Pietenpol-List: Re: Trailing edge treatment
Posted: Wed May 25, 2011 2:05 pm
by matronics
Original Posted By: K5YAC
Darnit! I should have known not to mention anything about this! My image tarnished!Dan HelsperPuryear, TN-----Original Message-----