Page 1 of 1
Pietenpol-List: Hardware Size
Posted: Sun Jun 10, 2012 2:53 pm
by matronics
Original Posted By: aircamperace(at)yahoo.com
Fantastic Bob!!!!....And you have a really nice looking aeroplane!!!Read this topic online here:
http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Hardware Size
Posted: Sun Jun 10, 2012 6:26 pm
by matronics
Original Posted By: "Gary Boothe"
Can anyone please share with me what size hardware they used on the forward rudderpedal brackets and control stick bearing mounts? I've searched the archivesand looked over the drawings with no luck. AN3s seem way too thick for the copilotsrudder pedals considering they are only going thru plywood.Thanks,RyanSent from my iPhoneOn Jun 10, 2012, at 3:53 PM, "moondogman" wrote:> > Fantastic Bob!!!!....And you have a really nice looking aeroplane!!!> > > > > Read this topic online here:> >
http://forums.matronics.com/viewtopic.p ... 220#375220> > > > > > > > > > ________________________________________________________________________________
RE: Pietenpol-List: Hardware Size
Posted: Sun Jun 10, 2012 8:06 pm
by matronics
Original Posted By: owner-pietenpol-list-server(at)matronics.com
AN3's, but with AN970 washers (large).Gary BootheNX308MB-----Original Message-----
Pietenpol-List: Hardware Size
Posted: Sun Jun 10, 2012 8:43 pm
by matronics
Original Posted By: Jim Boyer
RE: Pietenpol-List: Hardware Size
Posted: Mon Jun 11, 2012 4:37 am
by matronics
Original Posted By: owner-pietenpol-list-server(at)matronics.com
I used AN3's, with AN 970 washers under the nuts.Jack PhillipsNX899JPSmith Mountain Lake, Virginia-----Original Message-----