Page 1 of 1
Pietenpol-List: cabane fitting question
Posted: Tue Jul 03, 2012 7:40 pm
by matronics
Original Posted By: Ken Chambers
Subject: Pietenpol-List: cabane fitting question
RE: Pietenpol-List: cabane fitting question
Posted: Tue Jul 03, 2012 7:57 pm
by matronics
Original Posted By: owner-pietenpol-list-server(at)matronics.com
Ken,Do you have Long Fuse plans? In those plans it is noted as a 3" "filler".Whatever you decide to do, you must ensure that the distance between theforward and rearward fittings corresponds with the distance between thestruts, thereby preserving a parallelogram with the longerons, cabanes andcenter section. That allows you to move the center section back withoutchanging the angle of incidence. Gary BootheNX308MB
Pietenpol-List: cabane fitting question
Posted: Tue Jul 03, 2012 10:14 pm
by matronics
Original Posted By: Jim Boyer
Re: Pietenpol-List: cabane fitting question
Posted: Wed Jul 04, 2012 10:22 am
by matronics
Original Posted By: Ken Chambers
Subject: Re: Pietenpol-List: cabane fitting question
Pietenpol-List: Re: cabane fitting question
Posted: Wed Jul 04, 2012 2:48 pm
by matronics
Original Posted By: shad bell
Ken,Check this out:
http://forums.matronics.com/viewtopic.p ... 322880Bill C.Read this topic online here:
http://forums.matronics.com/viewtopic.p ... ______Date: Wed, 4 Jul 2012 13:50:34 -0700 (PDT)
Re: Pietenpol-List: Re: cabane fitting question
Posted: Wed Jul 04, 2012 3:51 pm
by matronics
Original Posted By: Ken Chambers
Subject: Re: Pietenpol-List: Re: cabane fitting question