Pietenpol-List: bottom fitting plate
Posted: Sun Sep 09, 2012 7:43 pm
Original Posted By: "Jack Phillips"
On pg. 3 of the plans in the lower left corner =9Cbottom fitting plate=9D that goes on the bottom of the fuselage. My question: should the 5/16=9D holes be 28 3/4=9D apart, as that would be the center to center width of the wing spars? Dennis________________________________________________________________________________
On pg. 3 of the plans in the lower left corner =9Cbottom fitting plate=9D that goes on the bottom of the fuselage. My question: should the 5/16=9D holes be 28 3/4=9D apart, as that would be the center to center width of the wing spars? Dennis________________________________________________________________________________