Original Posted By: "Michael D Cuy"
mike:Did you used the ones with rolled threads or cut threads. I have some withcut threads but all the old timers advise against using them for fear ofhairline cracks in between the threads.What do ya'll think about using cut threads?Thanks,Bert----- Original Message -----
Re: Pietenpol-List: 50 year old fork-ends .........question!!
Re: Pietenpol-List: 50 year old fork-ends .........question!!
Original Posted By: "Gary Meadows"
Subject: Re: Pietenpol-List: 50 year old fork-ends .........question!!In a message dated 8/7/00 6:10:41 PM Central Daylight Time, bconoly(at)surfsouth.com writes:>Cut threads are totally unacceptable for fork ends, as well as for any application that is in tension.Chuck Gantzer________________________________________________________________________________
Subject: Re: Pietenpol-List: 50 year old fork-ends .........question!!In a message dated 8/7/00 6:10:41 PM Central Daylight Time, bconoly(at)surfsouth.com writes:>Cut threads are totally unacceptable for fork ends, as well as for any application that is in tension.Chuck Gantzer________________________________________________________________________________