Original Posted By: Doug413(at)aol.com
>"It appears that after joining the wing panels to the center section(threepiece wing) there will be a gap of about 2 inches. What have folks beenusing to cover the gap and how is it held in place? Thanks, Dave Boyd,Champaign,IL"Aluminum fairings top & bottom will do the trick.Mike B Piet N687MB ( Mr Sam )________________________________________________________________________________
Pietenpol-List: wing gap
Re: Pietenpol-List: wing gap
Original Posted By: flyboy_120(at)webtv.net (Ed G.)
Subject: Re: Pietenpol-List: wing gapIn a message dated 2/20/01 6:08:51 PM Pacific Standard Time, mb-albany(at)worldnet.att.net writes:> "It appears that after joining the wing panels to the center section> (three> piece wing) there will be a gap of about 2 inches. What have folks been> using to cover the gap and how is it held in place? Thanks, Dave Boyd,> Champaign,IL"> > > Aluminum fairings top & bottom will David,I used small pan head screws 1/4" long into the rib cap strips and it has held very well.Doug Bryant Wichita Ks ________________________________________________________________________________
Subject: Re: Pietenpol-List: wing gapIn a message dated 2/20/01 6:08:51 PM Pacific Standard Time, mb-albany(at)worldnet.att.net writes:> "It appears that after joining the wing panels to the center section> (three> piece wing) there will be a gap of about 2 inches. What have folks been> using to cover the gap and how is it held in place? Thanks, Dave Boyd,> Champaign,IL"> > > Aluminum fairings top & bottom will David,I used small pan head screws 1/4" long into the rib cap strips and it has held very well.Doug Bryant Wichita Ks ________________________________________________________________________________