Pietenpol-List: Pietenpol's and Corvairs.

matronics · Post by **matronics** » Fri Dec 22, 2006 5:38 pm

Original Posted By: KMHeide
Hi Guys,I am trying to find out information on rpm levels and wooden prop sizes forthe Piet/Corvair combination.Could people flying with this combination let me know the following:-1 Size of prop2 Static RPM3 Typical cruise speed and rpm4 Full throttle speed and rpm5 Empty weight of aircraftI have some information from Hans and also from Al Schuberts book, "How Imake Wood Propellers". I would appreciate some more.Also, does anybody know if there is any correlation between Warp Drive pitchangles and Wooden Props?ThanksPeterWonthaggi, Australiahttp://www.cpc-world.com-- 6:45 PM________________________________________________________________________________Date: Fri, 22 Dec 2006 16:06:09 -0800 (PST)

matronics · Post by **matronics** » Fri Dec 22, 2006 5:48 pm

Original Posted By: "Rick Holland"

matronics · Post by **matronics** » Fri Dec 22, 2006 8:05 pm

Original Posted By: Mike Luther

matronics · Post by **matronics** » Sat Dec 23, 2006 1:33 am

Original Posted By: owner-pietenpol-list-server(at)matronics.com
JavierMy mixture control on the NAS31A has been blanked off. Bit the same as hardwiring the lever to the rich position.CheersPeter.-----Original Message-----

matronics · Post by **matronics** » Sat Dec 23, 2006 3:05 am

Original Posted By: Clif Dawson

matronics · Post by **matronics** » Sat Dec 23, 2006 9:37 am

Original Posted By: "Peter W Johnson"
not flying yet but I static at around 2900 with a 66x29 Tennessee prop.DJ----- Original Message -----

matronics · Post by **matronics** » Sat Dec 23, 2006 9:42 am

Original Posted By: Kip and Beth Gardner

matronics · Post by **matronics** » Sat Dec 23, 2006 5:27 pm

Original Posted By: owner-pietenpol-list-server(at)matronics.com
Thanks DJ.Peter.-----Original Message-----

matronics · Post by **matronics** » Mon Dec 25, 2006 11:29 am

Original Posted By: shad bell

matronics · Post by **matronics** » Mon Dec 25, 2006 11:39 am

Original Posted By: shad bell

Brodhead Pietenpol Association