Pietenpol-List: Re: West Coast Gathering

matronics · Post by **matronics** » Tue Jun 07, 2011 11:09 am

Original Posted By: "AircamperN11MS"
Looks like if you had a bending block about 3" long and 15/16" thick, you couldclamp the bracket around it after the 1st 90 degree bend so that you could hammerit around to get the 2nd 90 degree bend you need. That's what I would tryto do, can't think of any easier way to do it besides that.--------Billy McCaskillUrbana, ILtail section almost done, starting on ribs soonRead this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Pietenpol-List: Re: West Coast Gathering

matronics · Post by **matronics** » Wed Jun 15, 2011 8:50 am

Original Posted By: Michael Perez
Thanks John for the nice words. It was great to meet you. I also enjoyed yourvisit here. Next time you are in town I'll meet you at your place of businessfor lunch, you can show me Pics of your project. Sorry for the late reply but I have been out on a short vacation in the 5th wheeland just return this morning. Wife and I both got sick. Oh well, It's stillnice to get away. OK, Back to work.--------Scott LiefeldFlying N11MS since March 1972Steel TubeC-85-12Wire WheelsBrodhead in 1996Read this topic online here:http://forums.matronics.com/viewtopic.p ... ______Date: Wed, 15 Jun 2011 07:13:50 -0700 (PDT)

matronics · Post by **matronics** » Wed Jun 15, 2011 9:15 am

Original Posted By: Michael Perez

Brodhead Pietenpol Association