Pietenpol-List: ROTEC ENGINE

matronics · Post by **matronics** » Tue Oct 01, 2013 2:45 pm

Original Posted By: woodflier(at)aol.com
Dears, Is it possible assembly a Pietenpol aircraft using Rotec R3600, 9 cylinders and 150hp, three blades propeller?Thanks for your help. My Best Regards, Serranowww.kraussaero.com.br

matronics · Post by **matronics** » Tue Oct 01, 2013 3:02 pm

Original Posted By:> ** woodflier(at)aol.com
Subject: Re: Pietenpol-List: ROTEC ENGINEOne like this one?http://3.bp.blogspot.com/-sTq4dYbHWjk/U ... 2.jpgMario Giacummo2013/10/1 > Dears,> Is it possible assembly a Pietenpol aircraft using Rotec R3600, 9> cylinders and 150hp, three blades propeller?> Thanks for your help.> My Best Regards,> Serrano> www.kraussaero.com.br>

matronics · Post by **matronics** » Tue Oct 01, 2013 3:49 pm

Original Posted By: "Bill Church"
I am not certain we are all talking about the same supports. They are high lightedin the attached photo. I am not certain everyone is putting them in as Ihave seen completed wings without them.--------John FrancisRead this topic online here:http://forums.matronics.com/viewtopic.p ... ttachments: http://forums.matronics.com//files/p305 ... ___Subject: Pietenpol-List: Re: ROTEC ENGINE

matronics · Post by **matronics** » Tue Oct 01, 2013 8:14 pm

Original Posted By: contato(at)kraussaero.com.br
A 150 hp engine on a Pietenpol would be very expensive and unnecessary. Also three blade prop would be quieter but not necessary.Dick N. ----- Original Message -----