Original Posted By: Michael Perez
Pietenpol-List: Any Piets in the Bowling Green/Nashville area?
Re: Pietenpol-List: Re: fuselage side
Original Posted By: Michael Perez
Re: Pietenpol-List: Re: fuselage side
Original Posted By: Jack
Clever jig.... people to hold the parts in place while they cure (ha!)--------Jake Schultz - curator,Newport Way Air Museum (OK, it's just my home)Read this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Re: Pietenpol-List: Re: fuselage side
Clever jig.... people to hold the parts in place while they cure (ha!)--------Jake Schultz - curator,Newport Way Air Museum (OK, it's just my home)Read this topic online here:http://forums.matronics.com/viewtopic.p ... ___Subject: Re: Pietenpol-List: Re: fuselage side
Original Posted By: Michael Perez
Michael you built it upside down!Sent from my iPadJack TextorOn Dec 10, 2013, at 9:49 AM, Michael Perez wrote:> Loser! Here is the attached picture.> > > If God is your co-pilot...switch seats.> Michael Perez> Pietenpol HINT Videos> Karetaker Aero> www.karetakeraero.com> ________________________________________________________________________________Date: Tue, 10 Dec 2013 09:25:57 -0800 (PST)
Michael you built it upside down!Sent from my iPadJack TextorOn Dec 10, 2013, at 9:49 AM, Michael Perez wrote:> Loser! Here is the attached picture.> > > If God is your co-pilot...switch seats.> Michael Perez> Pietenpol HINT Videos> Karetaker Aero> www.karetakeraero.com> ________________________________________________________________________________Date: Tue, 10 Dec 2013 09:25:57 -0800 (PST)
Pietenpol-List: Re: Any Piets in the Bowling Green/Nashville area?
Original Posted By: "taildrags"
Another option for the leading edge piece is a length of brick moulding from a big box lumber yard. It is finger spliced clear pine in 16+ foot lengths. It is the piece between the brick face moulding at the bottom of the house and the siding above. A couple runs through a table saw and some sander work and it looks good. Once the plywood leading edge is glued on the concern over finger joints is not a problem.Ralph in SD________________________________________________________________________________Subject: Pietenpol-List: Re: Any Piets in the Bowling Green/Nashville area?
Another option for the leading edge piece is a length of brick moulding from a big box lumber yard. It is finger spliced clear pine in 16+ foot lengths. It is the piece between the brick face moulding at the bottom of the house and the siding above. A couple runs through a table saw and some sander work and it looks good. Once the plywood leading edge is glued on the concern over finger joints is not a problem.Ralph in SD________________________________________________________________________________Subject: Pietenpol-List: Re: Any Piets in the Bowling Green/Nashville area?