Pietenpol-List: Rust

matronics · Post by **matronics** » Fri Aug 22, 2014 10:03 am

Original Posted By: "Charles N. Campbell"
Ray,If you look closely you can see the stitching. Still difficult to see though.--------Scott LiefeldFlying N11MS since March 1972Steel TubeC-85-12Wire WheelsBrodhead in 1996Read this topic online here:http://forums.matronics.com/viewtopic.p ... ttachments: http://forums.matronics.com//files/piet ... ______Date: Fri, 22 Aug 2014 11:32:07 -0400Subject: Pietenpol-List: Rust

matronics · Post by **matronics** » Fri Aug 22, 2014 10:40 am

Original Posted By: gliderx5(at)comcast.net

matronics · Post by **matronics** » Fri Aug 22, 2014 10:44 am

Original Posted By: Ray Krause
Here are two articles.--------Semper Fi,Terry HandAthens, GARead this topic online here:http://forums.matronics.com/viewtopic.p ... ttachments: http://forums.matronics.com//files/elec ... __________

matronics · Post by **matronics** » Sat Aug 23, 2014 5:58 pm

Original Posted By: "Charles N. Campbell"
Subject: Re: Pietenpol-List: Rust

matronics · Post by **matronics** » Mon Aug 25, 2014 4:34 pm

Original Posted By:> anonymouse(at)woh.rr.com
Good stuff. Be sure and use the "egg crate buffing pad. Not lambs wool. Buy 2 pads=2C one for the coarse and one for the fine to remove swirl marks. I use this combo on restorations and absolutely no swirl marks even in bright sunlight on black paint.Doug Dever=0AIn beautiful Stow Ohio> Subject: Pietenpol-List: Re: beautiful Micro Mong latex paint

Brodhead Pietenpol Association

Pietenpol-List: Rust

Pietenpol-List: Rust

Pietenpol-List: Re: Rust

Re: Pietenpol-List: Rust

> Pietenpol-List: Re: beautiful Micro Mong latex paint