Pietenpol-List: RE: 11 ga. fence wire drag wires

[matronics]

Original Posted By: "Carl Loar"
Subject: Pietenpol-List: RE: 11 ga. fence wire drag wiresSteve, I did use turnbuckles to get my tensions right and to fine tune my trammel adjustments. Another writer expressed concern that the fence wire might stretch at the loops where it goes through the turnbuckle eyes, and I have thought about that too. I may end up changing out the wire for a/c cable.Matt Paxton________________________________________________________________________________

[matronics]

Original Posted By: owner-pietenpol-list-server(at)matronics.com
They say to get your numbers 90 days before you plan on getting inspected.It takes a couple of months to get them.CarlPiet # NX40044Please visit my website atwww.megsinet.net/skycarl-----Original Message-----

[matronics]

Original Posted By: Christian Bobka

[matronics]

Original Posted By: Jim Malley

[matronics]

Original Posted By: Jim Malley

[matronics]

Original Posted By: Doug413(at)aol.com
Subject: Re: Pietenpol-List: RE: 11 ga. fence wire drag wiresIn a message dated 2/24/01 8:57:29 AM Central Standard Time, Woodflier(at)aol.com writes:>Good decision, Matt________________________________________________________________________________

[matronics]

Original Posted By: Doug413(at)aol.com
Subject: Re: Pietenpol-List: Re: 1-19 cableIn a message dated 2/24/01 9:13:53 AM Pacific Standard Time, jgmalley(at)home.com writes:> I had little trouble bending the 1-19 cable around the thimbles, at> least that a rubber mallet doesn't solve. I did use two Nicopress> sleeves instead of one (the 1-19 has less twist than 7-19 and apparently> requires more holding surface).> > Jim Malley> > 7x7 cable is a good all aound cable for gen aviation. Doug Bryant________________________________________________________________________________