Original Posted By: Isablcorky(at)aol.com
All the machines you mentioned are good,but what you want to look for is "how easyis it to change blades" I run a Ryobi in my cabinet shop and the blade changeis a snap,takes me about 10 min. no brainer type of setup.Also how many sharpeningsare you going to get on a set of blades(I know Delta were very skimmpywhen I looked a few years back)? On the Ryobi the machine will likely burnout before I run out of blade to get sharpened,allthough somtimes I wonder,asI have been using it since 1995 and untold thousands of board feet have passedthrough it,but my guess is they all will stand up.Just a couple things to consider.Mike________________________________________________________________________________