Pietenpol-List: drive pins on Model A prop hub

matronics · Post by **matronics** » Fri Aug 12, 2005 10:28 am

Original Posted By: Rick Holland

matronics · Post by **matronics** » Fri Aug 12, 2005 10:55 am

Original Posted By: Rick Holland
RickI'll measure mine this weekend but I just wanted to give you a reminder of themore important measurement than the angle. Make sure that all said and done,with the tail up on level, that you will have 9"+ ground clearance for the prop.Dick N. ----- Original Message -----

matronics · Post by **matronics** » Fri Aug 12, 2005 1:33 pm

Original Posted By: DONALD COOLEY

Brodhead Pietenpol Association

Pietenpol-List: drive pins on Model A prop hub

Pietenpol-List: drive pins on Model A prop hub

Re: Pietenpol-List: Landing gear design sanity check

Pietenpol-List: Landing gear design sanity check