Page 1 of 1
Pietenpol-List: Trim Control
Posted: Sun Jun 15, 2008 10:17 am
by matronics
Original Posted By: shad bell
RE: Pietenpol-List: Trim Control
Posted: Sun Jun 15, 2008 6:19 pm
by matronics
Original Posted By: owner-pietenpol-list-server(at)matronics.com
John,I attached two springs to the bellcrank and fed cable through the rear seatbulkhead to a wheel in the cockpit. A quick turn on the wheel seems to beenough to hold the nose up a bit.Check out the pictures for more info.
http://www.cpc-world.com/images/IMG_110 ... rWonthaggi Australiahttp://
www.cpc-world.com _____
Re: Pietenpol-List: springs
Posted: Sun Jun 15, 2008 6:44 pm
by matronics
Original Posted By: Gene Rambo
This is the part number, as posted by Bill Church, for the John Deere spring in case anybody else is looking for the info.John Deere sells a spring that's a perfect match for the specs; its part number is T 143444, and it costs about $9.00. Its outer dia. is 1.5in.; full length( no load ) is 6.73" Bill C ----- Original Message -----