Page 1 of 1
RE: Pietenpol-List: Question for The Big Piet builders
Posted: Wed Feb 10, 2010 2:25 pm
by matronics
Original Posted By: owner-pietenpol-list-server(at)matronics.com
_____
Pietenpol-List: PROP FOR CORVAIR PIET
Posted: Wed Feb 10, 2010 2:40 pm
by matronics
Original Posted By: "Barry Davis"
Subject: Pietenpol-List: PROP FOR CORVAIR PIETMIKE THE PROP I GOT FROM TENNESSEE PROP WAS A 64 X 34 THAT THEY RECOMENDED FOR THE CORVAIR BASED PIETENPOL . I HAVEN'T RUN THE ENGINE YET SO I CAN'T VERIFY ANYTHING MORE .TED STONE________________________________________________________________________________
Pietenpol-List: Question for The Big Piet builders
Posted: Wed Feb 10, 2010 3:08 pm
by matronics
Original Posted By: Jeff Boatright
Pietenpol-List: PROP FOR CORVAIR PIET
Posted: Wed Feb 10, 2010 3:24 pm
by matronics
Original Posted By: Michael Groah
Pietenpol-List: Re: Question for The Big Piet builders
Posted: Wed Feb 10, 2010 3:25 pm
by matronics
Original Posted By: H RULE
Pietenpol-List: PROP FOR CORVAIR PIET
Posted: Wed Feb 10, 2010 3:33 pm
by matronics
Original Posted By: Jeff Boatright
Pietenpol-List: Re: PROP FOR CORVAIR PIET
Posted: Wed Feb 10, 2010 3:49 pm
by matronics
Original Posted By: "Cuy, Michael D. (GRC-RXD0)[ASRC Aerospace Corporation]"
Harvey: I'll bet your Franklin develops rated power at something like 2300 RPM,whereas the Corvair needs to turn 2900-3100 to develop full power. Thus, theshorter prop to control tip speed.--------Oscar ZunigaSan Antonio, TXAir Camper NX41CCRead this topic online here:
http://forums.matronics.com/viewtopic.p ... __________
Re: Re: Pietenpol-List: PROP FOR CORVAIR PIET
Posted: Wed Feb 10, 2010 8:05 pm
by matronics
Original Posted By: shad bell