Original Posted By: "dwilson"
Ray,This comes from the U.K. Pietenpol Type Acceptance Data Sheets. I have attacheda link to the entire paper, but the applicable part is pasted below.http://www.lightaircraftassociation.co. ... ----Semper Fi,Terry HandAthens, GARead this topic online here:http://forums.matronics.com/viewtopic.p ... ttachments: http://forums.matronics.com//files/imag ... ___Subject: Pietenpol-List: Another Picture
Pietenpol-List: Another Picture
Original Posted By: Ray Krause
Oshkosh did provide the motivation for a new throttle quadrant. I put this togetherin the shop yesterday. I really like the pistol grip. What do you think,leave the handle straight up and down or is there room to bend the lever 45degrees ? This provides 65 degrees of arc and 2 1/2 inch of travel.DanRead this topic online here:http://forums.matronics.com/viewtopic.p ... ttachments: http://forums.matronics.com//files/2014 ... __________
Oshkosh did provide the motivation for a new throttle quadrant. I put this togetherin the shop yesterday. I really like the pistol grip. What do you think,leave the handle straight up and down or is there room to bend the lever 45degrees ? This provides 65 degrees of arc and 2 1/2 inch of travel.DanRead this topic online here:http://forums.matronics.com/viewtopic.p ... ttachments: http://forums.matronics.com//files/2014 ... __________
Pietenpol-List: Re: Another Picture
Original Posted By: "tools"
Thanks, Scott. I will then be doing that. I thought most did it, but it could notsee the tape over the horizontal stab ribs on that picture last night, thatis what led to my question.We gotta meet some day, so close, but yet so far.Thanks again,RaySent from my iPad> On Aug 20, 2014, at 5:45 AM, "AircamperN11MS" wrote:> > > Ray,> > Yes, you do rib stitch all the tail surfaces.> > --------> Scott Liefeld> Flying N11MS since March 1972> Steel Tube> C-85-12> Wire Wheels> Brodhead in 1996> > > > > Read this topic online here:> > http://forums.matronics.com/viewtopic.p ... 850#428850> > > > > > > > > > ________________________________________________________________________________Subject: Pietenpol-List: Re: Another Picture
Thanks, Scott. I will then be doing that. I thought most did it, but it could notsee the tape over the horizontal stab ribs on that picture last night, thatis what led to my question.We gotta meet some day, so close, but yet so far.Thanks again,RaySent from my iPad> On Aug 20, 2014, at 5:45 AM, "AircamperN11MS" wrote:> > > Ray,> > Yes, you do rib stitch all the tail surfaces.> > --------> Scott Liefeld> Flying N11MS since March 1972> Steel Tube> C-85-12> Wire Wheels> Brodhead in 1996> > > > > Read this topic online here:> > http://forums.matronics.com/viewtopic.p ... 850#428850> > > > > > > > > > ________________________________________________________________________________Subject: Pietenpol-List: Re: Another Picture
Original Posted By: Ray Krause
I like it! Approaching HOTAS.... Some bend, not a full 45. Cheers!ToolsRead this topic online here:http://forums.matronics.com/viewtopic.p ... __________
I like it! Approaching HOTAS.... Some bend, not a full 45. Cheers!ToolsRead this topic online here:http://forums.matronics.com/viewtopic.p ... __________