Original Posted By: Marcus Zechini
I was aware you were at VPZ, but forgot. The staff here made sure I knew that they had talked to you.RickOn 1/20/2016 12:01 PM, Marcus Zechini wrote:>> Thanks! While I don't use in the Piet, the Piet did spend a night in > Valparaiso hangar last summer on way to Brodhead!>> On Jan 20, 2016 12:58 PM, "Richard Schreiber" > wrote:>> Marcus,> With Avare you actually need two apps. The Avare mapping program> and the Avare I/O add-on connection app. Start up the I/O app,> select WiFi connection then enter 4000 for the port. Next click on> listen. If all is right with the world you should immediately see> your are connected then a stream of date being displayed. Once you> have this, then launch Avare. One more thing to be aware of with> Stratux is if you have multiple navigation programs on your> device, make sure you completely close down the app before> switching to another app. This is especially true with the I/O app> Avare uses. The reason for this is once your are connected and> listening to Stratux on port 4000, that port is locked with a> handshake to the Stratux. That handshake needs to be shut down> before you can re-link with another app on the same port.>> Regards,> Rick Schreiber> Valparaiso, IN>> On 1/20/2016 11:14 AM, Marcus Zechini wrote:>>>> Thanks! Had to get Avare, as Garmin Pilot has proprietary>> interface. I have the WiFi add on, but still no joy. Will try>> port change.>>>> On Jan 20, 2016 9:52 AM, "bdewenter" > > wrote:>>>> >>>>> This thread is a bit off topic, but I wanted to pass along my>> experience with getting the Stratux ADS-B traffic to display>> within Avare on my Android tablet (finally had a reason to>> buy one!)>>>> Avare requires an add-on app for ADS-B. I needed to>> configure the add on app to use WIFI (not Bluetooth) and to>> use port 4000 (not the default of something like 4221).>>>> >From inside my house I was getting traffic alerts (so far>> only commercial airliners) showing up about 30 NM away. >> Pretty cool and fun to watch.>> also, my digital receiver antenna(s) are fully retracted.>>>> -------->> Bob 'Early Builder' Dewenter>> Dayton OH>>>>>>>>>> Read this topic online here:>>>>
http://forums.matronics.com/viewtopic.p ... 129#452129>>>>>>>>>>>>>>>> ==========>> br> fts!)>> r> > w.buildersbooks.com ">> rel="noreferrer" target="_blank">
www.buildersbooks.com>> >> rel="noreferrer">> target="_blank">
http://www.matronics.com/contribution>> -Matt Dralle, List Admin.>> ==========>> br> enpol-List" rel="noreferrer">> target="_blank">
http://www.matronics.com/Navigator?Pietenpol-List>> ==========>> FORUMS ->> eferrer" target="_blank">
http://forums.matronics.com>> ==========>> b Site ->> -Matt Dralle, List Admin.>> rel="noreferrer">> target="_blank">
http://www.matronics.com/contribution>> ==========>>>>>>>________________________________________________________________________________Date: Wed, 20 Jan 2016 13:43:44 -0500Subject: Re: Pietenpol-List: Re: ADS-B