Pietenpol-List: Pushrods.

matronics · Post by **matronics** » Sun Sep 12, 1999 12:20 am

Original Posted By: Earl Myers
Subject: Pietenpol-List: Pushrods.>Has anyone figured out how to install push rods on the controlls? Can it>be done. >>Steve>>________________________________________________________________________________

matronics · Post by **matronics** » Sun Sep 12, 1999 4:14 pm

Original Posted By: claude
Has anyone figured out how to install push rods on the controlls? Can itbe done. Steve________________________________________________________________________________

matronics · Post by **matronics** » Sun Sep 12, 1999 7:15 pm

Original Posted By: Greg Yotz
--->Has anyone figured out how to install push rods on the controlls? Can it>be done. >>SteveWhy?Mike B Piet N687MB ( Mr Sam )________________________________________________________________________________

matronics · Post by **matronics** » Sun Sep 12, 1999 10:12 pm

Original Posted By: vistin(at)juno.com
DON'T MESS WITH SUCCESS!-----Original Message-----

matronics · Post by **matronics** » Mon Sep 13, 1999 11:28 am

Original Posted By: DonanClara(at)aol.com
I installed a push/pull tube from the control stick to the elevatorwalking beam.No compelling reason to do so other than "I wanted to". Found out that rodend bearings are a LOT more expensive than pulleys also.If you do this, be careful not to change the control geometry.Greg>>> 09/12 3:14 PM >>>Has anyone figured out how to install push rods on the controlls? Can itbe done.Steve________________________________________________________________________________

Brodhead Pietenpol Association